1/29/2024 0 Comments Broadcom bcm43xx driver windows 10Wmaster0: Selected rate control algorithm 'simple'īcm43xx-phy0 debug: Adding Interface type 2īcm43xx-phy0 debug: Loading firmware version 351.126 ( 05:54:02)īcm43xx-phy0 debug: Radio enabled by hardwareīcm43xx-phy0 debug: bbatt(11) >= size of LO array Anyone else experienced that?īcm43xx-phy0 debug: Found PHY: Analog 3, Type 2, Revision 7īcm43xx-phy0 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 8 Either way, we have windows PCs sitting in other rooms getting 54mb connections with no problem, so i can only assume it is the fedora drivers that are at fault. iwconfig reports that the connection is actually 11mb/s. even though it is sitting right next to the wireless router. The other problem I have is that Network Manager appears to be telling me that the wireless speed never goes above 1mb/s, and trying to browse the web using the wireless connection certainly feels like that. When I manually connect to the wireless network using Network Manager, it asks for my keyring password, is there any way to stop this? Although it tells me that wlan0 is being brough up during boot, and gives a green OK, when I actually log into the desktop, Network Manager automatically connects me to the wired lan and not the wireless network. It doesnt quite seem to be working properly though. After following the various instructions in this thread I have eventually got to the point where my card is detected, is apparently activated during boot up, and connects when in gnome using Network Manager. I have been trying to get my pci card with broadcom bcm4318 chipset on all day.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |